Installing a mixer looks simple until crooked outlets, short tails, seized nuts and high pressure start causing trouble. Good installation is not only about getting water through the unit, but about building the connection so it lasts.
What mixers are installed most often
- Kitchen mixers. Standard, high-spout, pull-out and filter-compatible models.
- Basin mixers. Compact single-hole units.
- Bath and shower mixers. Wall-mounted models with eccentrics, diverter and shower set.
- Thermostatic and designer units. These need more careful compatibility and pressure checks.
What installation includes
- Isolating the water and preparing the point.
- Checking the mounting location. Hole size, condition of the sink, basin or wall.
- Installing the mixer body. With seals, fixings and alignment.
- Connecting flex tails or wall eccentrics.
- Turning water back on and checking every joint. Including aerator flow, temperature and mode switching.
What often triggers extra work
- Old flex tails. Better changed immediately.
- No isolation valves. Then every future service means shutting the whole apartment down.
- Crooked wall outlets. Especially critical in bath and shower points.
- Excess pressure. At 5–6 bar a new mixer should ideally be protected by an inlet reducer.
Typical prices in Israel
- Mixer installation — 220–450 ₪
- With new tails, eccentrics or minor fittings — 320–650 ₪
- With correction of an old connection point — higher depending on real scope
FAQ
Should flex tails be replaced when fitting a new mixer?
If the old tails have already served for years, yes. A new mixer on old hoses is a common cause of pointless return visits.
Can an expensive mixer be fitted onto old crooked wall outlets?
Sometimes yes, but not always neatly and not always reliably. The outlet geometry and thread condition should be checked first.
Is it normal for a mixer to drip for a few seconds after installation?
A small residual discharge from the spout can be normal, especially on high-spout mixers. Continuous dripping is not.